Achieving a spotless pool can involve more effort

by:Sinowon     2020-06-19
Basically, balancing the water is the first step. Remember to have a pH tester and pool-water testing kit beside you. Three factors affect the water's chemical balance pH, total alkalinity, and calcium hardness. These factors directly affect one another. In handling chemicals, refer to the instructions to guide you better. Remove physical dirt from the water using your broom and leaf net. Strainer baskets should also be rinsed. You may have to do these steps as often as necessary. Pool filters and cartridge filters are cleaned at least monthly. In balancing the water, use the water-testing kit to measure calcium hardness. Proper values would be between 200 and 400 parts per million. Following package instructions, carefully add calcium carbonate dihydrate to raise calcium hardness; add sodium hexametaphosphate to lower it. It will take some trial and error to get the values within the recommended range. Now, test the water's total alkalinity. The best range would be 100 to 120 ppm. Adding sodium bicarbonate increases alkalinity while adding sodium bisulfate lowers it. Add more chemicals as needed until the alkalinity is within the right range. Using your pH tester, check the water if the pH level is between the proper levels of 7.2 and 7.6. Balancing the water alone needs to be meticulously done. You may consider a trained team that checks and adjusts chemicals levels to give the pool water the right treatment. Treatment with chlorine is a popular method in disinfecting your pool. Chlorine ions help eliminate bacteria that cause certain diseases by destroying their cell wall and it dissolves bacterial nourishment in the water. Again, follow manufacturer's instructions to safely perform the treatment. You would also need to use goggles and rubber gloves. Remember to put the chlorine into the water, and not the other way around. Scoop chlorine granules into water in a nonmetal container then stir for about 30 seconds, and leave for 30 minutes to settle. Turn on the filter and pour the solution in the middle of the pool. You may have to use a diving board for that. Properly discard any sediment left in the container. Lastly, before allowing anyone to go in the pool, test the residual chlorine level to make sure it has gone back down below 3.0 ppm. This will take at least several hours. PH balancing, chlorine and chemical treatment, cleaning pump and skimmer baskets, brushing steps, walls and tiles, checking pump and all other equipments, removing pool debris and skimming the surface and vacuuming pool floor are among the expertise of pool cleaning services team in Las Vegas. Cleaning you pool regularly will make your pool safer and more enjoyable. Save time and money by hiring trusted, best pool cleaners in Las Vegas. It is necessary that you keep your pools clean to keep your family safe from sickness. That way, you can prevent unnecessary expenses from sickness while giving your family a good, quality time.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...