Which parts of the electronic universal testing machine are easily damaged?

by:Sinowon     2021-07-06
Which parts of the electronic universal testing machine are easily damaged?

Electronic universal testing machine is mainly used for testing nylon, plastic, leather, metal, rubber, braid and other materials.





It has the advantages of no pollution, low noise, high efficiency and so on. It has a wide range of speed and moving distance of the beam.


The electronic universal testing machine adopts a double-layer space floor structure, the upper space is stretched, and the lower space is compressed and bent.


According to ASTM / GB / ISO / JIS /
DIN and other standards, can perform tensile, shear compression, bending and various high and low temperature tests, and yield strength, tensile (compression, bending) strength, elongation, non-parameters such as proportional strength and elasticity Modulus.


The accessory is one of the most easily damaged parts in the electronic universal testing machine. The main attention of the attachment is to repair


In addition, since the material of this part is metal, it may rust and corrode during use.


The second most easily affected component of the electronic universal testing machine is the electric motor. The electric motor of the electronic universal testing machine controls the operation of the mechanical parts. It is an auxiliary motor indirect drive...


Although the possibility of the appearance of the motor is not very high, but if it is also used


The motor is the soul of the entire assembly, so the temperature, vibration and internal wires of the motor must be checked regularly, and the motor must be cleaned.


Sheet metal is the coating of electronic universal testing machine. Due to frequent


In addition to the above, common sheet metal damage is also the case. During transportation, the metal plate was severely deformed due to bumps and collisions on the way.


Although the sensor of the electronic universal testing machine is not easily damaged, if it is damaged, the consequences will be more troublesome.
The most important and longest fault of the sensor is the overload of the test force, and due to a series of chain reactions such as overload, such as collisions, the test machine cannot be tested. The sensor can only be replaced and then recalibrated to make it work properly.


The above is what parts of the electronic universal testing machine are easy to damage, I hope to help everyone!



Previous: CD-5000 Drawing Instrument
Next article: How to install the hydraulic cylinder of the hydraulic universal testing machine and the four points of maintenance of the oil source of the equipment
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...