Sinowon Ssc-1300 Carbon Arc Lamp Weather Resistance Test Chamber

Related Products

Sinowon SZH Series High Temperature Aging Test Chamber (Drying Oven)

Sinowon SY-UV-263 UV Aging Test Chamber

Sinowon SXD Series Xenon Lamp Weather Resistance Test Chamber

Sinowon SHQ Series Ventilation Aging Test Chamber

Product Information

The weather resistance test chamber for carbon arc lamps mainly uses solar-type carbon arc lamps as the light source. By changing the temperature (sample temperature, working chamber temperature), relative humidity, rainfall, etc., it simulates the comprehensive combination of light, heat, and water conditions of outdoor climate test chambers, and conducts artificial aging tests on the photochemical and mechanical properties of the tested materials.

Product Characteristic

Using PLC touch screen controller, the control is stable, and the main control parameters are light irradiance, working chamber temperature, sample rack temperature, and relative humidity, which can be automatically controlled by closed loop.

Specification

Commodity	Carbon arc Lamp Weather Resistance Test Chamber
Model	SSC-1300
Code#	221-261
Studio Dimensions(WDH）	110011001100mm
Exterior Dimensions (WDH）	130014002050mm(The actual product shall prevail!)
Use light source	SUNSHINE CARBON-ARC
Test time per cycle	60 hours, 4 groups of carbon rods are used each time

Temperature and humidity range: subject to the Black panel temperature
Temperature Range	40~70℃, black disk thermometer is 63±3℃ or 83±3℃
Humidity Range	When the temperature of the black disk thermometer is 63±3℃, the humidity is 50±5%.
Environmental Conditions	Room temperature: 25±3℃, relative humidity: 65±20%
Temperature control method	Electric control gate, automatic adjustment of intake and exhaust, balanced control of temperature.
Wet control mode	The immersion type electric heater produces water vapor and controls the humidity balance.
Simulation of rainfall water spray cycle control	Spray time can be set
	Spray for 18 minutes every 120 minutes (general type, rainfall cycle)
	Spray for 12 minutes every 60 minutes (rainy type, rainfall cycle)
	No spray (dry type, rainfall cycle)
Spray water volume	The total water volume of the nozzle at the spray pressure of 1.0kgf/cm2 is 2.10 ± 0.10L/min
Customer water supply	10E1 water pressure 1.5~3.0kgf/cm2
Water Quality	PH6.0~8.0, use hard water softening or pure water device when necessary
Structure and material	The test tank is made of stainless steel plate SUS304#, and the outer shell is made of steel plate painted
	The test tank door is equipped with an ultraviolet protection window
	The insulation layer is made of heat-resistant PU foam
Rainfall cycle time control	Power failure memory device (0-999min) with flow control: two-stage pressure regulation, pressure gauge and flowmeter (0-3.01/min)

Software Introduction

Sinowon Inquiry Information Table

To enjoy 5% discount off if fill in the following inquiring information table, the question or inquiry will be replied in a short time.

Thanks a lot for the cooperation

Sinowon SSC-1300 Carbon arc Lamp Weather Resistance Test Chamber